An experimental study on the shallow-level migmatization of ferrogabbros from the Fuerteventura Basal Complex, Canary Islands

authored by

Jürgen Koepke, Jasper Berndt, Francois Bussy

Abstract

Spectacular shallow-level migmatization of ferrogabbroic rocks occurs in a metamorphic contact aureole of a gabbroic pluton of the Tierra Mala massif (TM) on Fuerteventura (Canary Islands). In order to improve our knowledge of the low pressure melting behavior of gabbroic rocks and to constrain the conditions of migmatization of the TM gabbros, we performed partial melting experiments on a natural ferrogabbro, which is assumed as protolith of the migmatites. The experiments were performed in an internally heated pressure vessel (IHPV) at 200 MPa, 930-1150 °C at relatively oxidizing conditions. Distinct amounts of water were added to the charge.From 930 to 1000 °C, the observed experimental phases are plagioclase (An_60-70), clinopyroxene, amphibole (titanian magnesiohastingsites), two Fe-Ti oxides, and a basaltic, K-poor melt. Above 1000 °C, amphibole is no longer stable. The first melts are very rich in normative plagioclase (>70 wt.%). This indicates that at the beginning of partial melting plagioclase is the major phase which is consumed to produce melt. In the experiments, plagioclase is stable up to high temperatures (1060 °C) showing increasing An content with temperature. This is not compatible with the natural migmatites, in which An-rich plagioclase is absent in the melanosomes, while amphibole is stable. Our results show that the partial melting of the natural rocks cannot be regarded as an "in-situ" process that occurred in a closed system. Considerable amounts of alkalis probably transported by water-rich fluids, derived from the mafic pluton underplating the TM gabbro, were necessary to drive the melting reaction out of the stability range of plagioclase. A partial melting experiment with a migmatite gabbro showing typical "in-situ" textures as starting material supports this assumption.Crystallization experiments performed at 1000 °C on a glass of the fused ferrogabbro with different water contents added to the charge show that generally high water activities could be achieved (crystallization of amphibole), independently of the bulk water content, even in a system with very low initial bulk water content (0.3 wt.%). Increasing water contents produce plagioclase richer in An, reduces the modal proportion of plagioclase in the crystallizing assemblage and extends the melt fraction. High melt fractions of >30 wt.% could only be observed in systems with high bulk water contents (>∼2 wt.%). This indicates that the migmatites were generated under water-rich conditions (probably water-saturated), since those migmatites, which are characterized as "in-situ" formations, show generally high amounts of leucosomes (>30 wt.%).

Organisation(s)

Institute of Mineralogy

External Organisation(s)

University of Lausanne (UNIL)

Type

Article

Journal

LITHOS

Volume

69

Pages

105-125

No. of pages

21

ISSN

0024-4937

Publication date

08.2003

Publication status

Published

Peer reviewed

Yes

ASJC Scopus subject areas

Geology, Geochemistry and Petrology

Electronic version(s)

https://doi.org/10.1016/S0024-4937(03)00049-5 (Access: Closed)